The AD8232 Heart Rate Monitor is a cost-effective board. It is use to measure the electrical activity of the heart. This electrical activity charts as an ECG or Electrocardiogram and output as an analog reading. ECGs can be extremely noisy, this Heart Rate Monitor acts as an op amp to help obtain a clear signal from the PR and QT Intervals easily.

The AD8232 is an integrated signal conditioning block for ECG and other bio-potential measurement applications. It is designed to extract, amplify, and filter small bio-potential signals in the presence of noisy conditions such as  motion or remote electrode placement creates.

The AD8232 Heart Rate Monitor breaks out nine connections from the IC that you can solder pins, wires, or other connectors to. SDN, LO+, LO-, OUTPUT, 3.3V, GND provide essential pins for operating this monitor with an Arduino or other development board. Also provided on this board are RA (Right Arm), LA (Left Arm), and RL (Right Leg) pins to attach and use your own custom sensors. Additionally, there is an LED indicator light that will pulsate to the rhythm of a heart beat. Biomedical Sensor Pads and Sensor Cable are required to use the heart monitor and can be found in the Recommended Products section below.

Note:

This product is only for Prototypes. This product is not a medical device. And it is not use as such. And it does not diagnose or treat.

Features:

• Operating Voltage – 3.3V
• Analog Output
• Leads-Off Detection
• Shutdown Pin
• LED Indicator
• 3.5mm Jack for Biomedical Pad Connection

Shipping List:

1. AD8232 Heart Rate Monitor × 1
2. ECG cable × 1
3. Electrode × 3

Documents:

• Schematic
• Eagle Files
• Hookup Guide
• Datasheet (AD8232)
• GitHub (Design Files & Example Code)
• Product Video