Microcontroller

Description The PIC18F4431-I/P is a high-performance PIC18 family 8-bit powerful (200 nanosecond instruction execution) yet easy-to-program CMOS flash based Microcontroller packs powerful PIC®(RISC) architecture with up to 16 MIPS of processing power. This product offer all of the advantages of the well-recognized high-performance x16...

Overview: PIC16C711 8-Bit CMOS Microcontroller is a  Microcontroller with 18 pins. Link For Datasheet: https://cdn.datasheetspdf.com/pdf-down/P/I/C/PIC-16C-711.pdf Specifications:  Program Memory Type: OTP Program Memory Size (KB): 1.75 CPU Speed (MIPS/DMIPS): 5 SRAM (KB): 68 Timers: 1 x 8-bit ADC Input: 4 ch, 8-bit Temperature Range (°C): -40 to 85 Operating Voltage Range...

Description The PIC16F819 Microcontroller belongs to the Mid-Range family of the PICmicro® devices. The devices differ from each other in the amount of Flash program memory, data memory and data EEPROM (see Table 1-1). A block diagram of the devices is shown in Figure...

Description PIC16F886 8 Bit Microcontroller is a microcontroller good for experimenting and developing applications because it has a high flash memory rewrite cycle. Also, there are a lot of tutorials and support available online. The controller has 16KBytes flash memory which is enough for...

Description APM2.8 Flight Controller is an upgraded version of 2.5 2.6 with a Built-in Compass for FPV RC Drone Aircraft is the new APM2.8 flight controller. The sensors are exactly the same as the APM 2.6 flight controller, however, this has the option to...

Description Atmel AT89C51 Microcontroller and belongs to Atmel’s 8051 family. ATMEL 89C51 has 4KB of Flash programmable and erasable read only memory (PEROM) and 128 bytes of RAM. It can be erased and program to a maximum of 1000 times. In 40 pin AT89C51,...

PIC16F876 Microcontroller Features: 1• Pinout compatible to the PIC16C73B/74B/76/77 2• Interrupt capability (up to 14 sources) 3• Eight level deep hardware stack 4• Direct, indirect and relative addressing modes 5• Power-on Reset (POR) 6• Power-up Timer (PWRT) and Oscillator Start-up Timer (OST) 7• Watchdog...

Description GENERAL DESCRIPTION ■ PACKAGE OUTLINE The NJM2606 Low Voltage Dc Motor Controller are integrated circuits with wide operating supply voltage range for DC motor speed control. Especially, the NJM2606A is suited for the applications requiring low staturation output voltage. FEATURES 1. Operating Voltage...

Description General Description Download ?The FP5138 Boost controller IC in Pakistan is a boost topology switching regulator control IC for battery-used applications field. The FP5138 includes a totem-pole single output stage for driving NPN transistor or N-MOS, high precision reference (0.5V) for comparing output...

Description 28/40/44-Pin High-Performance, Enhanced Flash USB Microcontrollers

Description PIC16F88 16F88 Microcontroller The PIC16F88 features 8 MHz internal oscillator, 256 bytes of EEPROM data memory, a capture/compare/PWM, an Addressable USART, a synchronous serial port that can be configured as either 3-wire Serial Peripheral Interface (SPI™) or the 2-wire Inter-Integrated Circuit (I²C™) bus,...

Description AT89C52 - 8 bit Microcontroller  belongs to Atmel’s 8051 families. AT89C52 has 8KB of Flash programmable and erasable read-only memory (PEROM) and 256 bytes of RAM. it has an endurance of 1000 Write/Erase cycles which means that it can be erased and programmed...

AT89S52 8052 IC DIP Mount 8 Bit Microcontroller Features – AT89S52 Compatible with MCS-51 Products 8K Bytes of In-System Reprogrammable Flash Memory Fully Static Operation: 0 Hz to 33 MHz Three-level Program Memory Lock 256 x 8-bit Internal RAM 32 Programmable I/O Lines Two...

PIC16F628A 16F628A Pic Microcontroller 18 Pin Microchip microcontroller

Specifications of Alters FPGA board EP4CE6E22C8N Cyclone Board IV Board: 1. Integrated EP4CE6E22C8N chip 2. Integrated JTAG interface, SOF download or. JIC 3. integrated 50 MHZ active crystal 4. integrated 4-key input 5 with 5 V to 3.3 V-chip AMS1117-3.3 6. 5 V power supply with switch 7....